1111

In this brief review, we will tell you about our new OBDII tracker, which is connected to the diagnostic connector of most cars and can read the CAN-bus data of the onboard computer according to the J1939 standard.

To install the device, just insert it into the diagnostic connector of the car. This connector is usually located in an easily accessible place for most cars. Often, the diagnostic connector is covered with a panel that interferes with the installation of a GPS tracker. For this, an extension cable can be used, which is not often needed and is purchased separately.

Key Features and Features

Acceleration sensor, with which you can analyze the aggressive driving of the driver and record the fact of the accident.

Built-in backup battery with a capacity of 170 mA / h.

SD card is used to record the route of movement in areas of unstable mobile communications. For example, in some parts of the route between settlements.

Built-in Bluetooth 4.0, which can be used to configure the device, connect additional Bluetooth sensors, read diagnostic data from the CAN bus by a mobile phone.

Separate reserved entrance to control the ignition of the car.

Sensor towing a car, is used as a means of protection against theft.

Food from 10 to 30 V and is suitable for automobile and trucks.

Software features (WEB version, iOS, Android apps):

Exact location.

Exact mileage.

Driving directions.

Parking and stopping.

All data is stored for more than 1 year.

Hour meter.

In addition to standard functions, information is transmitted to the system:

About fuel level

Engine load

Coolant temperatures

Engine speed

Voltage on-board vehicle network

Backup battery voltage

Throttle Position

Engine oil temperature.